Chainsaw chains are very sharp, for your safety, please wear protective gloves when operating. In order to avoid injury when installing the chain, the gains outweigh the losses. The following operation steps require you to always pay attention to the details.
Chainsaw operation steps:
1. Loosen the compression knob and remove the compression cover.
2. Install one end of the saw chain on the sprocket, the other end of the saw chain is sleeved on the guide plate, and the middle guide teeth are just caught in the guide groove of the guide plate. Note: The teeth of the chain are facing forward!
3. Install the guide plate on the rechargeable chainsaw. Note: The rechargeable electric saw has a device to adjust the tension of the chain. When installing the guide plate, make sure that the adjustment block is inserted into the positioning adjustment hole at the end of the guide plate.
4. Install the compression cover on the guide plate and turn the compression knob clockwise.
5. Turn the chain tension knob to adjust the tension of the chain. The adjustment standard is: lift the chain in the middle of the guide plate by hand, and 3 or 4 middle guide teeth can be exposed.
6. Tighten the pressing knob, and the chain saw guide plate and chain are installed.
In addition to this, there are a few other things to keep in mind:
1. The chain will be stretched at the beginning of the use of the new chain. Please check it frequently and adjust it to the appropriate tension, because the loose chain length is easy to derail, which may lead to rapid wear of the chain and the guide plate.
2. The chain must be stuck on the sprocket. After the installation is completed, please check again.
