Chainsaw chain how to grind chainsaw chain how to install

How do you grind the chain of a chainsaw
Chainsaw chains are generally rarely ground, are directly replaced, if you want to grind with a small surname slowly grinding. Buy the chain model corresponding to the circle, grinding along the crossing can be. It is good to have a forward setback, but the other side is the opposite direction is not good
The method of chainsawing is as follows:
1. When the chainsaw chain uses the hacking-cutting tool, the hacking-cutting advance speed is not easy to be too fast, and the force is too strong to avoid the hacking-cutting teeth (breaking edge).
2, hacking-cutting chain cutter head, hacking-cutting 3 to 6 times to make the chain cutter head sharp can be, hacking-cutting too many times to make the chain cutter head curling, but also reduce the hacking-cutting and cutter life
life
3. When cutting the chain cutter head, after cutting more than a dozen times, knock the other metal with the cutter several times to shake off the chip in the tooth, which can be used normally.
4, to avoid wet, stained oil or other dirt, so as not to rust or slip, not with other hard tools stacked together, which will damage the surface of the teeth, affect the effect of the cutting.
Choosing a clasp with an ergonomic handle can make clasp work easier and more efficient while reducing the risk of injury.
How to install chainsaw chain
Chainsaw chain is very sharp, in order to ensure your safety, please wear protective gloves when operating.
1. Loosen the pressing knob and remove the pressing cover.
2, one end of the saw chain is installed on the sprocket, the other end of the saw chain is set on the guide plate, and the guide tooth is just stuck into the guide plate guide groove. Note: The knife teeth of the chain face forward.
3. Install the guide plate on the charging saw. Note: The charging saw has a device to adjust the tension of the chain. When installing the guide plate, the adjustment block must be stuck into the set at the end of the guide plate
Bit adjustment hole.
4. Install the clamping cover on the guide plate and turn the clamping knob clockwise
5. Turn the chain tensioning knob to adjust the tension of the chain. The adjustment standard is: lift the chain in the middle of the guide plate by hand to expose 3 or 4 middle guide teeth
6, tighten the pressing knob, chainsaw guide plate and chain installation completed
Chainsaw chain installation precautions
1, the new chain in the early use of the chain will be stretched, please check and adjust to the appropriate tension, because the loose chain length is easy to derail, may lead to rapid wear of the chain and guide.
2, the chain must be stuck on the sprocket, after installation, please check again.