The difference between pneumatic tools and power tools, in hardware tools, power tools and pneumatic tools are two very common and used tools, according to the weight volume ratio of the output power is large, in the case of the same output power, smaller and lighter than power tools. There is no overload failure, even if the pneumatic tool is overloaded. The tool simply stops rotating, and once the overload phenomenon is lifted, it will resume normal operation by itself, which has no impact on the tool and will not cause any failure; If the power tool overload work, heat, and even burn the motor, the maintenance cost is high, affecting the work schedule and work efficiency. Serious will also threaten the safety of the operator's life.
1, working capacity: both provide a variety of different working methods, but the pneumatic tool speed adjustment and output power adjustment is simple, in the case of the same output power, more small and lightweight. In addition, pneumatic tools can provide more levels of choice in the speed range, there is no heating and overload failure, overload when the start tool only stops rotating, once the overload phenomenon is lifted, normal operation is resumed.
2, environmental adaptability: In terms of environmental application ability, the water resistance of pneumatic tools is stronger. Although soaking water is harmful to tools, it will not cause electrical sparks like hardware power tools, causing harm. And because the pneumatic tool can use the internal combustion engine air pump, it can adapt to a variety of bad or harsh environments.
3, economy: in terms of economic performance, the initial investment of power tools is less, but the long-term use of energy consumption is higher, and the cost of tool maintenance and replacement is also higher. The initial investment in pneumatic tools requires the establishment of air pressure pipeline equipment, but long-term use is low in energy consumption and tool maintenance.
